Breckwell Control Panel with Wiring Harness

This is the first generation of digital control panels for most Pellet stoves. For stoves with a 4 RPM auger motor.
INCLUDES WIRING HARNESS to purchase the Control Board without Harness CLICK HERE
If you have an early digital control panel (2002 or older) for one of the following units, this is the control panel that you need:
P23 - up to 7165
P23I - up to 2242
P24 - up to 53663
P24I - up to 53794
P2000 - up to 11779
P2000I - up to 22207
P2700 - up to 8444

Serial numbers are approximate and should not be the only source of validation for the part.  Serial numbers may be off by as much as 10 units either way.

If your serial number is higher than those listed above, then you will need the C-E-401 Control Panel.

When installing, it doesn't matter which of the low limit thermodisks you attach the wires to. With the new digital board this thermodisk will allow the auger to run as well as turn off the blowers when the stove is turned off. With the old system the stove had a separate thermodisk to shut the blowers off.